Monday, August 18, 2014

Flash Lights with HT2014L

Flash Lights with HT2014L




This scheme is almost the same with a flash light with LM3909. In this scheme only requires IC HT2014L as a leader, and a resistor and LED. For voltage here need ration power around 4.5 V. You can apply this series to a wider scale in comparing the use IC LM3909. For the scheme are below:



flash

Related Posts:

  • Subwoofer amplifier with 30W output powerAmplifier circuit is very suitable for use in subwoofer amplifier system based on IC SI1030G. Amplfier has 30W output with 8 ohm impedance. Supply voltage required minimum of 12 volts and a maximum of up to 22 volts DC.Compon… Read More
  • Car Amplifier with IC LA4445This circuit using IC LA4445 , this is stereo amplifier with power output 2 X 18 Watt, with this circuit you can use to car amplifier or to other elctronics device. Speaker use woofer with impedance 4 Ohm with power up to 20 … Read More
  • Build a Bridge Wiring diagram Schematic With One Power SupplyThis is simple Bridge Circuit Diagram With One Power Supply. For systems with only one power supply, two op amps act as instrumentation and buffer amps. The OPA111 AM buffers the reference mode of the bridge and applies that … Read More
  • Temperature Regulator Circuit with TIP122 Wiring diagram SchematicFor best efficiency,make good thermal contact between the 40 ohm resistor,the TIP 122,the 3 diodes and the temperature controlled entity , the components all give off heat. We have some minor changes to the draft Roy. Roy A 4… Read More
  • Schematic Audio Amplifer with IC AN315This Schematic Require voltage 9 - 18 Volt. Good voltage for this schematic is 12 V. This is Mono amplifier with output 5,5 Watt and impedance 8 Ohm. You can make this Circuit easily because i give simple and clear scheme.See… Read More

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.