Simple 13 Color LED Rainbow Wiring diagram Schematic

Only a few years ago, the choice of LEDs was limited to IR, red, yellow, and green. The LED manufacturers have been busy extending the spectrum, and filling in the gaps. The latest generation of organic LEDs (OLEDs) has added some dazzling new colors to the spectrum. This schema uses a set of 13 differently colored LEDs to generate a full color spectrum. The photo does not fully represent the colors generated due to camera limitations. The real-world display is very eye-catching. If you want to "trick out" your PC, this schema is for you. Forget about those boring blue PC light displays.

Simple 13 Color LED Rainbow Circuit Diagram

Specifications:

• Operating Voltage: 6-12V DC
• Operating Current: 145ma at 12V DC

Theory:

The LM2940T-5.0 low dropout voltage regulator converts the 6-12V DC input power to regulated 5 Volts. It was chosen over a standard 7805 regulator so that the schema could maintain regulation while operating on a 6V battery. The 1N4001 diode protects the schema from reverse polarity, if a battery or power supply capable of generating over 1 amp is used, a 1 amp fuse should be installed between the supply and the schema. The 5 Volts is used to drive each of the LEDs through individual current limiting resistors.

The resistor values were determined experimentally for equal brightness. Values are given as examples only, different sources of LEDs will require different resistor values. Resistor selection turns out to be the most difficult part of the diagram construction. A 100 ohm resistor in series with a 1K pot could be used in place of each resistor if individual brightness adjustments are desired. The table below lists the LED colors and wavelengths.

LED Color Wavelength Description

Deep Red 700nm ---------

Red 660nm traditional red

Orange Red 635nm "high efficiency" red

Orange 623nm also called red orange

Amber 594nm ---------

Yellow 588nm & traditional yellow

Yellow Green 567nm traditional green

True Green 523mn --------

Cyan 501nm verde green, blue green

Aqua 495?nm ---------

Deep Blue 470nm ultra blue

Powder Blue 430nm first generation "powder blue"

Violet 410nm ---------

Construction:

The schema was built on a prototype perforated board with printed solder pads. The schemary is hand-wired on the back side of the board. Care should be taken when soldering to the LEDs, a clip-on heat sink should be used while soldering the leads. Care should be taken to avoid zapping the LEDs on the violet side of the spectrum, they are sensitive to static electricity. The schema board can be mounted on a piece of white hardboard, the white paint reflects the colors nicely.

Use:

Apply power to the schema and enjoy the colorful glow. Do not stare directly into the array at close range for extended periods, some of the LEDs are extremely bright.

Taking The Circuit Further:

The spectrum could be extended on both the IR and UV sides. A brief scan through the Mouser catalog indicates the availability of these IR wavelengths: 940nm 880nm, 875nm, 870nm, 850nm. UV LEDs at 400nm, 395nm and 380nm are also available. There are also many LED colors available with wavelengths between the 13 colors shown, the colors selected were chosen for an evenly spaced color spectrum.